California Department of Resources Recycling and Recovery (CalRecycle) 

Calculating Maximum Allowable Disposal for Diversion Rate Measurement

Note: This page contains historical data from CIWMB's (now known as CalRecycle) statewide goal measurement prior to 2007 that estimated a diversion percentage. For 2007 and subsequent years, CalRecycle compares reported disposal tons to population to calculate per capita disposal expressed in pounds/person/day. This new goal measurement system is described in the Goal Measurement: 2007 and Later web page.

References

  • Statute: Public Resources Code (PRC) Section 41780.2
  • Regulations: Title 14, California Code of Regulations (14 CCR), Section 18794.1

Maximum Allowable Disposal Facts

  1. Jurisdictions must use the estimated reporting year generation amount calculated by the Board-approved Adjustment Method to calculate a maximum allowable disposal in each reporting-year.
  2. Generation equals disposal plus diversion. To meet diversion rate requirements, the estimated 1995 generation (100%) = maximum allowable disposal (75%) + diversion goal (25%). To meet diversion rate requirements the estimated 2000 generation (100%) = maximum allowable disposal (50%) + diversion goal (50%).
  3. Starting in 1995, 25% is to be diverted, so no more than 75% can be disposed. Starting in 2000, 50% is to be diverted, so no more than 50% can be disposed.
  4. The Board may have granted a reduction in the diversion rate requirement for rural jurisdictions in 1995, and may grant a reduction for any jurisdiction in 2000 (refer to PRC Section 41785).
  5. If a jurisdiction does not have a Board-approved reduced diversion rate requirement, then it will multiply its estimated reporting year generation amount by 0.75 beginning in 1995, and by 0.50 beginning in 2000.
  6. If a jurisdiction has a Board approved reduced diversion rate requirement, then it will use:
               100 % - reduced diversion rate percentage = maximum allowable disposal percentage.
                         (For example, 100% - 15% = 85% or 0.85)
  7. The calculated maximum allowable disposal will be compared with the actual Reporting-year Disposal to determine the diversion rate achieved.
  8. This process does not correct for base-year problems, disposal reporting problems, or changes in conditions not corrected by the adjustment method.

Diversion Rate Measurement Home

Last updated: December 3, 2010
Local Government Central http://www.calrecycle.ca.gov/LGCentral/ 
Local Assistance & Market Development: LAMD@calrecycle.ca.gov (916) 341-6199